BMW M3 Forum.com (E30 M3 | E36 M3 | E46 M3 | E92 M3 | F80/X)

BMW M3 Forum.com (E30 M3 | E36 M3 | E46 M3 | E92 M3 | F80/X) (http://www.m3forum.net/m3forum/index.php)
-   E46 M3 (2001-2006) (http://www.m3forum.net/m3forum/forumdisplay.php?f=9)
-   -   Misfires on 4-6 after header install (http://www.m3forum.net/m3forum/showthread.php?t=593677)

gregdepot Tue, Nov-14-2017 07:04:07 PM

Misfires on 4-6 after header install
 
I don't think pre O2s are crossed sinced they not seem long enough and only one miss fire code at 7400 rpm on cylinder 2. (206)


Maybe the bank 2 pre sensor was damaged? At 840 and 1640 rpm missfires on 4-6 cylinders



Any suggestions?


Uploading an image failed and I don't think photo bucket works anymore

erickrayos Tue, Nov-14-2017 08:54:25 PM

Re: Misfires on 4-6 after header install
 
from what I understand, pre sensor doesn't have anything to do with your fuel/air mixture. its just there so that it can see if there's any difference in readings between the pre and post cat sensors and based on the post cat sensor readings that's where the computer adjust the fuel/air ratio.. but then again I don't think it would cause you to get misfires...

try putting the coils from that cylinder to another and see if the misfire moves to that. and or spark plugs.

95bullet Tue, Nov-14-2017 09:07:13 PM

Re: Misfires on 4-6 after header install
 
The pre cat bank 1 and bank 2 sensors are excatly the same length. You likely have them switched.

The pre cats adjust mixture post cats and egt verify the cat functionality

gregdepot Tue, Nov-14-2017 10:19:42 PM

Re: Misfires on 4-6 after header install
 
It looks like the sensors were installed differently at the factory then diagrams and wire looms were backwards the car is now working


All times are GMT. The time now is 10:22:23 PM.

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
Copyright 1999-2017 M3Forum.com